“Glenn and his crew remodeled our kitchen and a bathroom. Honest, on schedule, and the finish work is the kind of detail you don't see anymore. He picked up a phone every time we called.”
Flooring
Flooring in Taunton, MA.
Flooring shows every flaw in the subfloor, every gap in the install, every misread of the moisture content. We level, acclimate, and install with the patience the material requires. Refinishing too: three-pass sanding, dust containment, oil or water finish.
As Bristol County's seat and CW Services' home base, Taunton homeowners get the fastest response, the most local references, and the same crew start to finish. We've worked on every era of Taunton home, from Whittenton mansards to East Taunton capes to newer subdivisions off Route 44, and our trade partners are all within a short drive.
- Cost range
- $2,500–$22,000
- Typical timeline
- 4–11 days
- What we handle
- 5+ project types
Quick answer
Flooring in Taunton, MA from CW Services LLP runs $2,500–$22,000 per project, with a typical timeline of 4–11 days. Glenn and his crew handle every trade in-house with licensed electrical and plumbing partners. Every project carries a written 1-year workmanship warranty, MA HIC license, and $2M general liability.
Free walk-through within 3–5 business days, written estimate the same week, and same crew start to handoff. Call (774) 623-9476 or request a free estimate.
What we do
Project types.
CW Services LLP handles 5 types of flooring work in Taunton, MA, from hardwood install to subfloor leveling. Pricing typically runs $2,500–$22,000 per project, depending on scope and finish level. Glenn scopes the right project type during a free walk-through and writes the estimate the same week.
Hardwood install
Solid or engineered, nail-down or glue-down.
Hardwood refinishing
Sand, stain, seal, water or oil-based finish.
Luxury vinyl plank (LVP)
Click-lock or glue-down. On slab or subfloor.
Tile flooring
Kitchens, bathrooms, mudrooms, entries.
Subfloor leveling
Self-leveler or shim-and-plywood, whichever the situation calls for.
Process
From walk-through to handoff.
A flooring project at CW Services LLP runs in 5 stages: walk-through & estimate, acclimate the material, subfloor prep, install, transitions, trim, walk-through. Glenn walks the home, writes the estimate the same week, pulls every permit, and the same crew handles every trade through finish. Typical timeline is 4–11 days, with a written 1-year workmanship warranty included.
- 01
Walk-through & estimate
Glenn checks subfloor flatness, moisture, transitions. We write the estimate the same week.
- 02
Acclimate the material
Hardwood and LVP sit in the home for 5–7 days before install. Skipping this is why floors gap.
- 03
Subfloor prep
Level dips, screw down squeaks, vapor barrier where needed. The base matters more than the floor.
- 04
Install, transitions, trim
Stagger cuts properly, transition pieces seated tight, shoe molding caulked at the wall.
- 05
Walk-through
Final clean, walk-through. Written workmanship warranty.
FAQs
Common questions.
If your question isn’t answered here, call or text Glenn. Usually a 12-minute reply.
How long does install take?
A 600 sqft hardwood install runs 4–6 days. Refinishing runs 3–5 days plus dry time.
Can you install over my existing floor?
Sometimes, depends on the substrate and ceiling height. We will tell you when it makes sense and when it does not.
Will refinishing be dusty?
Less than you expect. We use dust-containment sanders and seal off rooms. Plan to be out of the house for finish coats.
What does it cost?
LVP starts around $5–$8/sqft installed. Hardwood install is $9–$14/sqft. Refinishing existing hardwood is $4–$6/sqft.
Choosing a contractor
DIY vs handyman vs CW Services.
For a flooring project, here’s the honest tradeoff. Some scopes really are best handled by a handyman. Some truly should be DIY.
Pulls permits & meets inspectors
DIYNoHandymanPartialCWYesLicensed for structural changes
DIYNoHandymanNoCWYesCoordinates licensed electrical & plumbing
DIYNoHandymanPartialCWYesWritten estimate, line-itemed
·DIYn/aHandymanPartialCWYesSame crew start to handoff
·DIYn/aHandymanNoCWYesWritten 1-yr workmanship warranty
DIYNoHandymanNoCWYesInsurance + workers comp on every employee
DIYNoHandymanPartialCWYesEPA Lead-Safe certified (pre-1978 homes)
DIYNoHandymanNoCWYesDaily clean-up + dust control
DIYPartialHandymanPartialCWYesHonest about scope creep before extra work
·DIYn/aHandymanPartialCWYes
Honest answer: a handyman is right for a leaky faucet or trim repair. A licensed GC is right for moving plumbing, walls, or systems. We’ll tell you straight, and refer you out when we’re not the right fit.
Reviews
Same crew. Same standard. Years of receipts.
Also serving
Flooring across Southeast MA.
Related
Other services we handle.
Ready to talk through your project?
Free estimate. Written same week. Glenn walks the project, Megan handles scheduling. No pressure, no salesperson.